Dry Extract question

Homebrewing with extract? Share your thoughts here!
Post Reply
User avatar
Iceman
Posts: 43
Joined: 5 years ago
Favourite Beer: Peche Mortel
Location: Guelph, ON
Contact:

Dry Extract question

Post by Iceman » 5 years ago

Most of my brewing so far has been with LE, but the last one I made had DE as well. I ran into the problem of the DE clumping up on the package (because of the steam from the water) when I was adding it to the boil.

Is there a way to help avoid this problem in the future?
___________________________________________________________________________________________
Bottled: Imperial Stout, Brown Ale, Amber Ale, IPA
Primary: n/a
Secondary: n/a
Up Next: Bohemian Pilsner, Double IPA

Mr_Tastyfish
Posts: 446
Joined: 6 years ago
Favourite Beer: Homebrewed beer
Location: Bowmanville, ON

Re: Dry Extract question

Post by Mr_Tastyfish » 5 years ago

When I was using dry malt extracts, I remember running into the same issue. The easiest solution is to simply rinse the bag/container with some of the hot wort. It's a little easier to use a more rigid container than just a plastic bag IMO.

User avatar
XXXXX
Administrator
Posts: 688
Joined: 8 years ago
Favourite Beer: Cold
Location: Hamilton, ON
Contact:

Re: Dry Extract question

Post by XXXXX » 5 years ago

Yup I agree with Tastyfish, just rinse with a cup of wort using a rigid container (bowl, whatever).
Mmmm... Beer... *drool*

User avatar
Iceman
Posts: 43
Joined: 5 years ago
Favourite Beer: Peche Mortel
Location: Guelph, ON
Contact:

Re: Dry Extract question

Post by Iceman » 5 years ago

Ok, thanks guys - much appreciated!
___________________________________________________________________________________________
Bottled: Imperial Stout, Brown Ale, Amber Ale, IPA
Primary: n/a
Secondary: n/a
Up Next: Bohemian Pilsner, Double IPA

User avatar
Greedy Dragon Brewing
Posts: 171
Joined: 5 years ago
Favourite Beer: IPA

Re: Dry Extract question

Post by Greedy Dragon Brewing » 5 years ago

Agree with the comments above. The other alternative is to pour the contents into a measuring bowl prior to use. The extract is added to boiling water so no worries about disinfecting the bowl as long as it is clean. cheers
Come check me out at https://www.youtube.com/user/GreedyDragonBrewing
If you like what you see please like, share, and subscribe. CheerZ

kombat
Member
Posts: 385
Joined: 7 years ago
Favourite Beer: Broadhead Wildcard

Re: Dry Extract question

Post by kombat » 5 years ago

Like Greedy Dragon, I measure out my DME into a stainless steel bowl while weighing it, then just keep it there until it's time to add it to the boil. No issues with it sticking, and if so, it's stainless steel, so I can just (carefully) dunk it in the boiling wort to rinse it off. Of course, clean the bowl right away, as that stuff is STICKY.

Post Reply